How to properly protect your favorite speakers? How to make the speaker have the longest life? How to make the speaker maintain good sound quality for a long time? Let's talk about the "speaker maintenance experience" with the speaker.

Placement:

Don't ignore this seemingly simple problem. Many parts of the speaker are very precise parts. If you are exposed to direct sunlight for a long time, or placed in an overheated place beside the heater, it will cause the cabinet. Surface blistering or aging of electrical components. Do not leave the speaker in a damp place for a long time, so as not to make the voice coil rust or mold. At the same time, in order to make the speaker not dissonant when working, you should avoid too close to the magnetic equipment such as mobile phones.

Usage environment :

The various components of the speaker are mostly sensitive to changes in temperature and humidity. If the temperature is too low or too high, it will affect the stability of these parts. If the temperature is less than 5 °C, the hanging edge will easily become brittle. Therefore, if you work at a lower temperature, you must “warm up” the speakers, play some soft music in advance and turn down the level. After about 20 minutes, you can rest easy and use your speakers with confidence. If the temperature is higher than 35 ° C, the voice coil overheating will cause sound deterioration. It is recommended to avoid using the speaker at high temperatures or use it under the condition of air conditioning temperature control.

Humidity has a great impact on the operation of the speakers. Too dry conditions will cause the veneer outside the speaker to burst or crack. The solution is to purchase a humidifier or put a basin of water in the room. If the humidity is too high, it will easily cause the sound basin to be damp and moldy, resulting in weak sound playback. Use the desiccant before using. In addition, the dust removal of the speaker is very important. When the speaker is idle, the dust cover must be added. It can also prevent children from touching the sound reproduction unit while reducing dust and unnecessary loss. The surface of the speaker can be cleaned by using a towel dampened with water and then wiped, but do not let the speaker unit get wet. After wiping, be sure to wait until the moisture is dry before turning it on, otherwise it will easily cause short-circuit heating.

Use maintenance:

Active speakers Because of the built-in amplifier, the chip should avoid the direct impact of large currents. Therefore, it is best to turn the speaker to the minimum and then turn it on again after switching the speaker. When not in use for a long time, turn off the switch and unplug the power cord. After playing for a long time at a large volume, the rear panel of the speaker will become very hot, so pay special attention to it. In addition, the volume of the speaker should not be too large, about 1/2 is most suitable, because the sound unit will be burned in the state of maximum volume. When you sing karaoke, try to stay away from the speakers, and don't point the microphone at the speakers to avoid whistling or even burning the tweeter.